When frequent location update is not required for stationary asset, TLP1-LF is the one you go with. 1-4 updates per day will keep the battery at a healthy consuming rate for long term tracking.
Regular location updates to reduce power consumption
Thick and solid casing and rugged construction for outdoor uses
non-rechargeable 8100 mAh/3.6V battery, can be replaced from us at a small cost
Tested in 5-meter water pressure environment for 15 hrs
Alerts sent when device is pulled off from asset
It can be mounted with magnets, screws, polyurethane or heavy-duty tape by end users
Operating Band:FDD: B1/B2/B3/B4/B5/B8/B12/B13/B19/B20/B25/B28
TDD: B39 (Cat M1 only)
EGPRS 850/900/1800/1900MHz
1 report per day: 5 years
GNSS Chipset:Qualcomm Gen 8C GNSS receiver
Parallel GNSS:GPS+Glonass+Galileo+Beidou
Position Accuracy (CEP):Autonomous < 2m
Standalone TTFF:Cold start: < 29s
Warm start: < 27s
Hot start: < 1s
Data Transmission:4 Pin port with magnet
Network, GNSS Antenna:Internal only
Indicator LED:Network, GNSS and Battery level
FOTA:Yes
Physical Power Switch:1
Light Sensor:1 back light sensor
Temperature Sensor:1 temperature sensor
Waterproof:IP67
Dimensions:69.3mm*143mm*24.8mm (2.73” *5.63” *0.98”)
Weight:210g (7.4oz)
Battery:Non rechargeable 8100 mAh/3.6 V Li battery
Data Communication:Magnetic USB cable
Operating Temperature:-20℃ ~ +80℃ (-4°F ~ 176°F)
Mounting:Magnet/Screw
Transmit Protocol:TCP, UDP, MQTT, SMS
Geo-fence:Support up to 64 internal geo-fence regions
Low Power Alarm:Sending alarm when battery is low
Motion Detection:Motion alarm based on internal 3-axis accelerometer
Removal Alarm:Sending alarm when the light sensor detecting the light changing
FCC, PTCRB, CE, RCM, AT&T, US Cellular